How to Update Galaxy S II GT I9100 with Pure Look S3 Custom ROM Firmware

Design by Nature or Pure Look S3 is an all new custom ROM firmware which is made for Samsung Galaxy S II GT I9100 is here. This custom ROM firmware is built on the firmware which is dubbed as XWLPG firmware. In the process of this article, we will be checking out on what are the list of pre requisites you need to install along with a detailed guide on how to apply this firmware update. Please be informed that this is not an official firmware update rolled out Samsung Electronics Ltd. This all new custom ROM firmware comes with the looks of Samsung Galaxy S3 as all the icon and layout framework.

Disclaimer: 

We should not be held liable for any damage caused in the process of applying this rooting process in your device. It is very unlikely that your device will be damaged if you follow all the instructions to the point which are mentioned in procedure.

Rooting Information: 

For applying this custom ROM firmware update, your Galaxy SII GT I9100 smartphone is rooted on any of the Stock Firmware version. Please be informed that once the device is rooted, the warranty will get void. The only way with which you can revoke the root access is by re applying with any of the Stock firmware update.


Core Features of Pure Look S3 Custom ROM Firmware:

• Improved Touch Sensitivity – GPU Acceleration
• WiFi tweak saving battery – Scrolling improved responsiveness
• SONY BRAVIA: Increase the quality of photos and video
• Modified Dalvik VM 180MB heap size
• The user interface rendering with GPU
• Internet connection ottimizzat – Fewer delays in calls
• Sensor Screen Delay off – Memory management improved
• Added Power Panel: Reboot – Download – Hot boot
• MicroSD Card speed 1024KB / s
• Market connections Fix Speed
• Switch-off the camera when the battery charge 0%
• Video / audio profiles 24-20Mbps/192Kbps_44100Hz
• Disabled increased volume for incoming calls
• Removal of the options for reducing noise in call
• Off SMS to MMS – no auto conversion

Procedure to Update Galaxy SII with Pure Look S3 Custom ROM Firmware:

• Download the Galaxy SII Design by Nature Custom ROM firmware from here to your computer. Connect your phone to computer in the mass storage mode and place the downloaded zip file in your phone’s SD Card.

• Once placed, disconnect the device and turn off your device so that it can be then entered in the recovery mode.

• Recovery mode in Galaxy S II I9100 can be entered by holding the Volume Up button + the Home key button (the middle button). While holding these both buttons, turn ON your device. In recovery mode, select “Wipe data/factory reset” & “Wipe Cache partition”. Additionally, select “advanced” and clear the Dalvik cache too if you are on the custom ROM firmware.

• Up next, Select “install zip from sd card” > “choose zip from sd card” and then select the “Design by Nature” custom ROM firmware which you have placed in your device. Once the process of firmware installation is done, the device will land back on the recovery mode screen.

• Select “reboot system now” for restarting the device in the normal mode. Please note that once installed, you can check the same from the Settings > About Phone path where it will show as XWLPG firmware.

Note: If your S2 refuses to boot up or fails to get started, then you will have to re insert the battery and reboot the device so as to start your phone. If the firmware update gets failed, then you need to again re try the whole process.

So there you go, you have now successfully install the firmware in your Galaxy S II. 

Posted in: droid hacks,updates